M210 QUICK START PROGRAMMING GUIDE
1. PLACE SENSORMAT ® PAD 1. Remove the Sensormat® pad from the plastic bag. 2. Place the pad on a bed or a chair. 3. Cover the pad with a sheet, incontinence pad, etc. 4. Run cord under mattress/chair pad, or behind chair. 5. Connect the pad to the monitor (step #2).
3. POWER THE M210 MONITOR Power Supply: 1. Plug the M210 monitor’s power supply into the electrical outlet. 2. Install batteries for backup power (3 CR123A lithium batteries). Batteries: 3. Insert the batteries into the battery compartment and tighten the screw on the battery cover. TIPS IMPORTANT : Use only Sensormat® pads manufactured by STANLEY Healthcare. • Bed pad: place approximately 3 to 5 inches below the bend in the mattress. • Chair pad: place across seat, approximately 4 inches from back of chair. • For all pads, consider the individual’s position in the bed/chair and adjust placement accordingly.
2. CONNECT SENSORMAT ® PAD TO MONITOR 1. Plug the Sensormat® pad(s) into the M210 monitor. 2. If using a Nurse Call system, plug the Nurse Call cord into the M210 and into the Nurse Call interface.
Two pads may be connected to one monitor (one to bed and one to chair). If using only one pad, it can be plugged into either port.
USING THE M210 FALL MONITOR
MONITORING AN INDIVIDUAL 1. Place the individual on the bed/chair. 2. The Reset button flashes green for 3 seconds, then provides a positive confirmation tone indicating system is working correctly. IMPORTANT : Always verify the green monitoring light is illuminated before leaving the room. When the monitor is operating by battery power only, the Reset button will not stay illuminated but instead it will flash green when monitoring. SETTING AN ALARM DELAY Setting a delay allows in-bed movement without triggering an alarm • Two consecutive presses on the Reset button (while NOT in alarm mode) changes the delay setting from the current setting to a new one. • The Alarm Delay cycles through from 0s to 1s to 2s . RESPONDING TO AN ALARM When an individual attempts to exit bed/
HOLD MODE Allows caregiver 30 seconds to remove an individual from a monitored pad without triggering an alarm. If the indi- vidual’s weight is applied to the pad while in Hold mode,
normal monitoring resumes. SETTING HOLD MODE
Hold Mode: Press the Reset button for 3 seconds. Listen for audible message “ Hold Mode, 30 seconds” • When the Hold Mode time has completed, the monitor resumes normal operation. • To exit Hold Mode before the time has passed, press and hold the Reset button for 2 seconds. − Alternately, to exit Hold Mode before the full 30 seconds, return the individual to the pad.
chair, an alarm sounds in the room and at the nurses station (if Nurse Call is connected). 1. Attend to the individual. 2. Press the Reset button to cancel the alarm. − If a Nurse Call is in use, reset the M210 first, followed by Nurse Call.
6
Powered by FlippingBook